
Double click to zoom in
AD707LVP Low Viscous High Solids Epoxy
AD707LVP is used to prime heavily shot blasted high build commercial floor systems.
This product does not self level as well as AD707 100% solids, so if applying heavy, such as at a rate of less than 100 sqft per gal, then use AD707. At that rate it can be easily applied with or without squeegee. If you are unsure, it helps to float it out with a squeegee then roll over to smooth it out. At rates over 150 sqft per gal, then you will not need a self-leveling material like AD707, AD707LVp will work great for you. Another option is to purchase AD707 and add 1 cup of xyxlene to 3 gals and essentially have the same product as AD707LVP. Doing that will yield a tad more material but many customers would rather not hassel with doing that and adding the extra cost of the xylene. Alot of your decision depends on the square footage. Questions, just shoot us an e-mail and we can help you.
Colors are close representations and will vary depending on your monitor.
Standard Colors
Beige
Light Gray
Medium Gray
Off White
Tile Red
White
Additional Colors
Blue
Brown
Dark Gray
Green
Light Blue
Tan
AD707LVP is a fairly new product specifically formulated for use as a primer over a heavily shot blasted floor. This formula has been adjusted to provide a second use as a high solids build coat to substitute AD707. AD707LVP is the low viscous formula of the AD707. It is 93% solids and much easier to spread. No squeegee is needed as provides very similar results. We recommend this product over AD707 if you don’t feel comfortable working with the thicker 100% solids epoxy. Many customers gave very positive feedback after going with the AD707 saying that it wasn’t as bad as they thought but we would rather make sure you are prepared to the fullest so you have a pleasant installation experience. Last thing you want is to be short on material because you were not prepared or warned about its properties. Read data sheets before buying any 100% solids epoxy. It really is not that bad we just want you to give you the knowledge to lay a long lasting, great looking floor.
Related Products
-AD15- AD15 Water Based Epoxy Primer
AD15 is a two component water based epoxy coating that exhibits excellent characteristics that rival solvent based products. AD15 has superb chemical resistance, abrasion resistance, and substrate penetration.
-AD30- AD 30 Water Based Urethane
AD30 is a two component water based catalyzed aliphatic high performance urethane emulsion sealer/topcoat that exhibits excellent abrasion resistance without the objectional solvent odors associated with other urethane products. This product has an extremely fast set time and a very long pot life.
-AD144- AD144 - Polyamide Epoxy Primer
AD144 is a two component solvent based epoxy coating that exhibits excellent characteristics for abrasion resistance, chemical resistance, and substrate penetration. This product is suitable as a primer for high build coatings and urethane or as a stand alone coating.
-AD322- AD322 Hi-Performance Urethane Topcoat
Use for top coating epoxy flake systems or pigmented to add an extra layer of protection with or without non-skid.
-AD358- AD358 High Solids High Performance Urethane
AD358 is a three component aliphatic urethane floor finish that exhibits excellent characteristics for abrasion resistance,, chemical resistance, flexibility, weathering and UV stability.












